Once you have the tank bolts removed, ensure that the toilet lid is down, and then carefully lift the tank out of its position. Let it sit for a few minutes and then try it again. If you still run into trouble, take a bit of CLR and spray it on the fastener.

You may also need to tap it a few times with the end of the pliers to break up some of the rusted metal. If this is the case, take your pliers and firmly grab the nut or bolt head, and slowly turn it to the left. Remember that these nuts shouldnРІР‚в„ўt be secured too tightly, though, in some cases, they may be too corroded to turn just by using your hand. Once youРІР‚в„ўve removed all of the water from the tank, grab a wrench and remove the nuts connecting the tank to the toilet bowl. Next, remove any remaining water from inside the tank. After turning off the water supply line, flush the toilet to empty all of the water from the bowl.

If the toilet still runs, youРІР‚в„ўll need to turn the valve a bit more. Then, turn the valve clockwise about a half-inch to shut it off completely. Take an adjustable wrench and loosen the nut on the valve. You can do this with the toiletРІР‚в„ўs water supply valve, which is located near the back wall of the toilet, typically on its left side. Now that youРІР‚в„ўve zeroed in on the cause of the leak, cut off the water supply line before doing anything further. Turn Off the Water and Empty the Toilet Tank If you look at the space between the two, you should be able to determine where the leak is starting. Next, work your way up the back of the toilet - where the bowl connects to the tank. To perform a thorough inspection, start at the bottom of the toilet, near the floor. Note that there are a few other places where your toilet can leak, too. If your bathroom stays on the more humid side, this is something to keep an eye on as they may corrode at an accelerated rate. These parts can wear out over time, causing a tank bolt to loosen - which can be dangerous for the tank. Perform an Inspection to Find the Leak SourceР”В«efore you can fix the leak, youРІР‚в„ўll need to closely inspect the toilet tank bolts to see where itРІР‚в„ўs originating.Р”Р„re they corroded? If this is the case, youРІР‚в„ўll definitely need to replace them with newer ones.Р”Р„nd the same thing goes for the washers and nuts holding the bolts in place.

How to remove toilet tank bolts